Discharge Headlight Control Module Removal/Installation

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Incorrect servicing of the discharge headlight control module could result in electrical shock. Before servicing the discharge headlight control module, always refer to the "Discharge headlight service warnings." (See DISCHARGE HEADLIGHT SERVICE WARNINGS .)

Disconnect the negative battery cable.
Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION .)
Remove the front combination light. (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION .)
Remove the screws shown in the figure, then remove the discharge headlight control module cover.

Fig 1: Removing Discharge Headlight Control Module Cover
Courtesy of MAZDA MOTORS CORP.
Remove the screws shown in the figure.

Fig 2: Removing Discharge Headlight Control Module Cover Screws
Courtesy of MAZDA MOTORS CORP.
Disconnect the discharge headlight control module connector.

Fig 3: Identifying Discharge Headlight Control Module Connector
Courtesy of MAZDA MOTORS CORP.
Remove the cover and disconnect the discharge headlight connector.

Fig 4: Identifying Discharge Headlight Connector
Courtesy of MAZDA MOTORS CORP.
Pull out the discharge headlight control module wiring harness and remove the control module.

Fig 5: Identifying Discharge Headlight Control Module Wiring Harness & Control Module

Courtesy of MAZDA MOTORS CORP.

Install in the reverse order of removal.