Ignition Switch Removal/Installation [Without Advanced Keyless Entry And Push Button Start System]

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the column cover. See COLUMN COVER REMOVAL/INSTALLATION .
Pull the pin in the direction of the arrow shown in the figure and release the lock.
Disconnect the connector.

Fig 1: Identifying Ignition Switch And Connector
Courtesy of MAZDA MOTORS CORP.
Remove the screw.

Fig 2: Identifying Ignition Switch And Screw
Courtesy of MAZDA MOTORS CORP.
Remove the tabs.
Install in the reverse order of removal.

Fig 3: Identifying Ignition Switch And Tab

Courtesy of MAZDA MOTORS CORP.