No. 5 Programming Procedure Due to Simultaneous Replacement of Immobilizer System-related Parts (PCM, Keyless Control Module, and Steering Lock Unit): Notes
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- The engine cannot be started if any step or procedure is skipped. Perform all procedures in the order of the steps.
NOTE:
- If the keyless control module is replaced, complete the configuration before performing the following procedure.
- When replacing the keyless control module or the steering lock, remove the valid keys or valid advanced keys from the vehicle (keep them 1 m or more from the vehicle) and switch the ignition on according to the directions on the M-MDS screen. Select, "There is no programmed ignition key and programmed advanced key" from the M-MDS screen.
CAUTION:
- Because the ignition is switched on using "Special Service Mode", the engine cannot be started during this IG cycle.
- Although the security light or the keyless warning light (red) Illuminates or flashes, this does not indicate an improper procedure. Continue to perform the procedure as indicated.
CAUTION:
M-MDS menu
- Parameter Reset
- Ignition Key Code Erase and Program
- Program Additional Advanced Key
- Steering Lock Unit Programming
PROGRAMMING CONDITIONS
| Replacement part | M-MDS execution menu/ sequence | Conditions |
|---|---|---|
| Keyless control module and PCM | 1→2→3→4 |
|
| Keyless control module and steering lock unit | ||
| Keyless control module, PCM, and steering lock unit | ||
| PCM and steering lock unit | 1→4 | Have two or more keys to be programmed after the replacement. |