Sliding Door Glass Removal/Installation

Fully open the sliding door glass.
Disconnect the negative battery cable.
Remove the following parts:
1. Side door garnish (See SIDE DOOR GARNISH REMOVAL/INSTALLATION .)
2. Rear side trim (See REAR SIDE TRIM REMOVAL/INSTALLATION .)
3. Sliding door trim (See SLIDING DOOR TRIM REMOVAL/INSTALLATION .)
4. Sliding door quarter glass (See SLIDING DOOR QUARTER GLASS REMOVAL/INSTALLATION .)
Connect the power window subswitch connector.
Connect the negative battery cable.
Adjust the door glass position as shown in the figure.

Fig 1: Adjusting Door Glass Position
Disconnect the negative battery cable.
Remove the screws.

Fig 2: Identifying Service Hole Cover And Sliding Door
Remove the service hole cover in the direction of the arrow (1), then remove the service hole cover in the direction of the arrow (2) while avoiding the wires.

Fig 3: Removing Service Hole Cover
Remove the hole plug.

Fig 4: Identifying Hole Plug And Sliding Door
CAUTION:
Fig 5: Lowering Sliding Door Glass
- If the bolts are removed without supporting the sliding door glass, the glass may fall off. Insert a hand through the service hole and lower the sliding door glass to the bottommost position while supporting the glass with your hand.
Remove the bolt.

Fig 6: Sliding Door And Bolt With Torque Specifications
Remove the sliding door glass in the direction of the arrow as shown in the figure.

Fig 7: Removing Sliding Door Glass
Install in the reverse order of removal.