Rear Body Control Module (RBCM) Inspection: Notes
- Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0] ).
- Remove the following parts:
- Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION ).
- Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION ).
- Rear scuff plate (LH) (See REAR SCUFF PLATE REMOVAL/INSTALLATION ).
- Trunk side trim (LH) (See TRUNK SIDE TRIM REMOVAL/INSTALLATION ).
- Remove the rear body control module (RBCM) from the body with the connector connected. (See REAR BODY CONTROL MODULE (RBCM) REMOVAL/INSTALLATION ).
- Connect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0] ).
- Verify that the voltages of each of the terminals are as indicated in the
TERMINAL VOLTAGE TABLE (REFERENCE) .
- If the voltage is not as indicated in the table, inspect the parts under Inspection item(s).
- If the system does not launch normally even though inspection items are normal, specify the location of the malfunction based on the instructions from the on-board diagnostic system and the symptom troubleshooting, and perform repairs.
- If the voltage is not as indicated in the table, inspect the parts under Inspection item(s).