Keyless Receiver Inspection: Notes
- Remove the following parts:
- Trunk end trim (See
TRUNK END TRIM REMOVAL/INSTALLATION
).
- Rear scuff plate (LH) (See
REAR SCUFF PLATE REMOVAL/INSTALLATION
).
- Trunk side trim (LH) (See
TRUNK SIDE TRIM REMOVAL/INSTALLATION
).
- Remove the keyless receiver with the connector still connected. (See
KEYLESS RECEIVER REMOVAL/INSTALLATION ).
- Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).
- If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s) and related wiring harnesses.
- If the system does not operate normally even though the parts under Inspection item(s) and related wiring harnesses do not have any malfunction, replace the keyless receiver.