Accelerator Pedal Position (App) Sensor Inspection: Notes

NOTE:

Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flowchart. (See HOW TO USE THIS SERVICE INFORMATION ).

Connect the M-MDS to the DLC-2.
Turn the ignition switch to the ON position.
Select APP1 and APP2 PID on the M-MDS.
Verify that the APP1 and APP2 PID is within the specification when the accelerator pedal not depressed. (See PCM INSPECTION ).

Fig 1: Identifying Data Link Connector Terminals
Courtesy of MAZDA MOTORS CORP.