LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2014 >> 3 SV, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic - Engine Controls (1 Of 6) >> DTC P0069 00: Manifold Absolute Pressure/Atmospheric Pressure Correlation Problem >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P0069 00: Manifold Absolute Pressure/Atmospheric Pressure Correlation Problem: Notes

DTC P0069:00 DETECTION CONDITIONS AND POSSIBLE CAUSES (SKYACTIV-G 2.0, SKYACTIV-G 2.5)

DTC P0069:00  Manifold absolute pressure/atmospheric pressure correlation problem 
DETECTION CONDITION 
  • The PCM monitors the difference between the intake manifold vacuum and the atmospheric pressure. If the difference is below -12 kPa {-0.12 kgf/cm 2  , -1.7 psi} or above 12 kPa {0.12 kgf/cm 2  , 1.7 psi}  when the following conditions are met, the PCM determines that there is a MAP sensor performance problem.

MONITORING CONDITIONS 
  • 12-15 s  from when ignition is switched off.

Diagnostic support note 
  • This is a continuous monitor (CCM).
  • The check engine light illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
  • PENDING CODE is available if the PCM detects the above malfunction condition during first drive cycle.
  • FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
  • DTC is stored in the PCM memory.
FAIL-SAFE FUNCTION  Not applicable
POSSIBLE CAUSE 
  • MAP sensor malfunction
  • BARO sensor (built-into PCM) malfunction
  • PCM malfunction
SYSTEM WIRING DIAGRAM  Not applicable
CAUTION:
  • Verify the malfunction symptom according to not only the PID value but also the symptom troubleshooting.
RELATED PIDS

Item (definition) Unit/Condition Definition Condition/Specification (Reference)
BARO KPa {MPa}, mBar {Bar}, psi, in H20 Actually measured barometric pressure input from barometric pressure sensor built into PCM
  • Displays BARO
V BARO sensor voltage
  • Ignition switched ON (at sea level): Approx. 4.08 V
MAP KPa {MPa}, mBar {Bar}, psi, in H20 Manifold absolute pressure
  • Displays MAP
V MAP sensor voltage
  • Ignition switched ON (engine off) (MAP: 101 kPa {1.03 kgf/cm2 , 14.6 psi}): Approx. 4.07 V
  • Idle (after warm up) (MAP: 33 kPa {0.34 kgf/cm2 , 4.8 psi}): Approx. 1.34 V
  • Racing (engine speed is 2, 000 rpm) (MAP: 26 kPa {0.27 kgf/cm2 , 3.8 psi}): Approx. 1.05 V
scientia non olet · About LEMON Manuals