Function Inspection Using M-MDS

STEP	INSPECTION	RESULTS	ACTION
1	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
1		No	Go to the next step.
2	PURPOSE: VERIFY IF POWER SUPPLY IS AFFECTED BY DTC RELATED TO DC-DC CONVERTER Switch the ignition off, then ON (engine off). Perform the DC-DC converter DTC inspection using the M-MDS. (See DTC INSPECTION [I-ELOOP] .) Is the PENDING CODE/DTC U3000:49 also present?	Yes	Go to the applicable PENDING CODE or DTC inspection. (See DTC U3000:49 [I-ELOOP] .) Go to the next step.
2		No	Go to the next step.
3	PURPOSE: VERIFY IF POWER SUPPLY IS AFFECTED BY DTC RELATED TO DC-DC CONVERTER Perform the DC-DC converter DTC inspection using the M-MDS. (See DTC INSPECTION [I-ELOOP] .) Is the PENDING CODE/DTC P1628:11 also present?	Yes	Go to the applicable PENDING CODE or DTC inspection. (See DTC P1628:11 [I-ELOOP] .) Go to the next step.
3		No	Go to the next step.
4	PURPOSE: DETERMINE IF MALFUNCTION CAUSED BY DC-DC CONVERTER Start the engine. Is "i-ELOOP charging. Stop the vehicle and wait a minute" displayed in the LCD?	Yes	Go to the TROUBLESHOOTING PROCEDURE to perform the procedure from Step 1.
4		No	Go to the next step.
5	PURPOSE: DETERMINE LOCATION OF MALFUNCTION OCCURRENCE FROM BLOWN STARTER 250 A FUSE Switch the ignition off. Inspect the STARTER 250 A fuse. Is the STARTER 250 A fuse blown?	Yes	Go to the TROUBLESHOOTING PROCEDURE to perform the procedure from Step 4.
5		No	Go to the TROUBLESHOOTING PROCEDURE to perform the procedure from Step 6.