Sensor Output Value Inspection
WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Switch the ignition off.
- Connect the M-MDS to the DLC-2.
- Select the following PIDs using the M-MDS:
- WSPD_SEN_LR (LR ABS wheel-speed sensor)
- WSPD_SEN_RR (RR ABS wheel-speed sensor)
- Start the engine and drive the vehicle.
- Verify that the display of the M-MDS shows the same value as the speedometer.
- If there is any malfunction, replace the ABS wheel-speed sensor.