Lighting Systems

WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Switch the ignition ON (engine off or on).
Turn the audio unit power on.
Select the following from the audio unit screen.
1. "Setup"
2. "Vehicle"
3. "Lighting"

Select the following items and change the setting.

HIGH BEAM CONTROL SYSTEM DESCRIPTION

Audio unit display	Function	Initial setting	Settings	Control module
High Beam Control	The high beam control (HBC) system can be switched between operable and inoperable.	On	On/Off	FSC

TURN LIGHT SYSTEM DESCRIPTION

Audio unit display	Function	Initial setting	Settings	Control module
3-Flash Turn Signal	The turn light system can be switched between operable and inoperable.	On	On/Off	Rear body control module (RBCM)

AUTO LIGHT SYSTEM DESCRIPTION

Audio unit display	Function	Initial setting	Settings	Control module
Auto-headlight On	Auto light sensor sensitivity can be changed.	Medium	Light/Medium Light/Medium/Medium Dark/Dark	Rear body control module (RBCM)

NOTE:

If the mode is set to "Light" and "Medium Light", the illumination level for illuminating the TNS and headlight increases. Therefore, the TNS and headlights illuminate when the ambient light is brighter than when the level is set to "Medium". In addition, if the mode is set to "Medium Dark" and "Dark", the illumination level for illuminating the TNS and headlights decreases. Therefore, the TNS and headlights illuminate when the ambient light is lower than when the level is set to "Medium".

ROOM LIGHT CONTROL SYSTEM DESCRIPTION

Audio unit display	Function	Initial setting	Settings	Control module
Interior Light Timeout - Door Open	The front/rear map light and courtesy light illumination time after any door is opened can be changed. The trunk compartment light illumination time after the trunk lid is opened can be changed.	30 minutes	60 minutes/30 minutes/10 minutes	Rear body control module (RBCM)
Interior Light Timeout - Door Closed	The front/rear map light and courtesy light illumination time after all the doors are closed can be changed.	15 seconds	60 seconds/30 seconds/15 seconds/7.5 seconds	Rear body control module (RBCM)