Adaptive Front Lighting System (AFS) Off Switch Inspection

WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The AFS OFF switch is integrated with the cluster switch.
For the AFS OFF switch removal/installation, refer to CLUSTER SWITCH REMOVAL/INSTALLATION . (See CLUSTER SWITCH REMOVAL/INSTALLATION .)

Remove the cluster switch. (See CLUSTER SWITCH REMOVAL/INSTALLATION .)
Verify that the resistance between cluster switch terminals B and C is as indicated in the table.

Fig 1: Adaptive Front Lighting System Circuit Diagram
Courtesy of MAZDA MOTORS CORP.
- If the resistance can be verified as indicated in the table, go to the next step.
- If not as indicated in the table, replace the cluster switch. (See CLUSTER SWITCH REMOVAL/INSTALLATION .)
  
  Fig 2: Condition Chart
  Courtesy of MAZDA MOTORS CORP.
Apply battery positive voltage to cluster switch terminal J, and connect terminal I to ground.
Verify that the LED illuminates.
- If the LED does not illuminate, replace the cluster switch. (See CLUSTER SWITCH REMOVAL/INSTALLATION .)
  
  Fig 3: Applying Battery Positive Voltage To Cluster Switch Terminal J
  Courtesy of MAZDA MOTORS CORP.