Diagnostic procedure

WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

DTC U0305:00/U0405:00 (DYNAMIC STABILITY CONTROL) DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	PERFORM VEHICLE CONTROL MODULE (V/C-MODULE) DTC INSPECTION Switch the ignition off. Using the M-MDS, perform the DTC inspection for the Vehicle Control Module (V/C-Module). (See DTC INSPECTION [VEHICLE CONTROL MODULE (V/C-MODULE)] .) Are any DTCs detected?	Yes	Go to applicable DTC inspection. (See DTC TABLE [VEHICLE CONTROL MODULE (V/C-MODULE)] .)
1		No	Go to the next step.
2	VERIFY THAT SAME DTC IS NOT PRESENT Clear the DTCs from the memory. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .) Are the same DTCs present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the Vehicle Control Module (V/C-Module), then go to the next step. (See VEHICLE CONTROL MODULE (V/C-MODULE) REMOVAL/INSTALLATION [MAZDA RADAR CRUISE CONTROL (MRCC) SYSTEM] .)
2		No	Go to the next step.
3	VERIFY THAT NO OTHER DTCs ARE PRESENT Are any other DTCs output?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .)
3		No	DTC troubleshooting completed.