Start Stop Unit Inspection: Notes

NOTE:

Because the start stop unit terminals 3A-3L and 4A-4L are inside the start stop unit and not exposed, the terminal voltage cannot be measured.
Terminals with terminal voltage that cannot be measured are not indicated in the terminal voltage table (reference).

Remove the following parts:
1. Column cover (See COLUMN COVER REMOVAL/INSTALLATION .)
Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).
- If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s) and related wiring harnesses.
  - If the system does not work normally even though the inspection items or related wiring harnesses do not have any malfunction, replace the start stop unit.