Basic Inspection
| STEP | INSPECTION | ACTION | |
|---|---|---|---|
| 1 | Measure the battery voltage. Is the battery voltage 10-14 V ? |
Yes | Go to the next step. |
| No | Recharge or replace the battery. (See BATTERY RECHARGING .) (See BATTERY REMOVAL/INSTALLATION .) |
||
| 2 | Inspect the TCM related harnesses, connectors and fuses. Are they normal? |
Yes | Go to the next step. |
| No | Repair or replace any malfunctioning parts according to the inspection result. | ||
| 3 | Switch the ignition to ON. When the selector lever is moved, does the shift position indicator light indication correspond to the selector lever position? Also, when other positions are selected from N or P during idling, does the vehicle move within 1-2 s ? |
Yes | Go to the next step. |
| No | Inspect the selector lever and TR switch. (See SELECTOR LEVER INSPECTION .) (See TRANSAXLE RANGE (TR) SWITCH INSPECTION .)
|
||
| 4 | Perform the road test. (See ROAD TEST .) Is the ATX operating normally? |
Yes | Go to the next step. |
| No | Repair or replace any malfunctioning parts according to the inspection result. | ||
| 5 | Inspect the ATF color and condition. (See AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION .) Are the ATF color and odor normal? |
Yes | Go to the next step. |
| No | Repair or replace any malfunctioning parts according to the inspection result. Flush the ATX and cooler line if necessary. |
||
| 6 | Perform the line pressure test. (See MECHANICAL SYSTEM TEST .) Is the line pressure normal? |
Yes | Go to the next step. |
| No | Repair or replace any malfunctioning parts according to the inspection result. | ||
| 7 | Perform the stall test. (See MECHANICAL SYSTEM TEST .) Is the stall speed normal? |
Yes | Go to the next step. |
| No | Repair or replace any malfunctioning parts according to the inspection result. | ||
| 8 | Perform the time lag test. (See MECHANICAL SYSTEM TEST .) Is the time lag within the specified? |
Yes | Go to the next step. |
| No | Repair or replace any malfunctioning parts according to the inspection result. | ||
| 9 | Inspect the value at the following PCM and TCM PIDs using the M-MDS (IDS). (See ON-BOARD DIAGNOSTIC TEST .) (See ON-BOARD DIAGNOSTIC SYSTEM PID/DATA MONITOR INSPECTION .)
Are the PID values normal? (See PCM INSPECTION .) |
Yes | Perform the symptom troubleshooting and follow the procedures. |
| No | Repair or replace any malfunctioning parts according to the inspection result. | ||