Body Control Module (BCM) Bracket No. 2 Removal/Installation

Disconnect the negative battery cable.
Remove the following parts:
1. Dashboard under cover (passenger's side) (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION .)
2. Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION .)
3. Side wall (See SIDE WALL REMOVAL/INSTALLATION .)
4. Center console box (See CENTER CONSOLE BOX REMOVAL/INSTALLATION .)
5. Console panel (See CONSOLE PANEL REMOVAL/INSTALLATION .)
6. Center console (See CENTER CONSOLE REMOVAL/INSTALLATION .)
7. Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [G66M-R] .)
8. Selector lever knob (ATX) (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .)
9. Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION .)
10. Front console (See FRONT CONSOLE REMOVAL/INSTALLATION .)
11. Side panel (See SIDE PANEL REMOVAL/INSTALLATION .)
12. Front scuff plate (passenger's side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
13. Front side trim (passenger's side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
14. Lower panel (passenger's side) (See LOWER PANEL REMOVAL/INSTALLATION .)
15. BCM (See BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION .)
Press and release the tab in the direction of arrow (1) as shown below, and pull BCM bracket No. 2 in the direction of arrow (2) shown below to remove it from the BCM.

Fig 1: Identifying Tab Releasing Direction And BCM Bracket No. 2 Pulling Direction
Courtesy of MAZDA MOTORS CORP.
Install in the reverse order of removal.