LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2014 >> MX-5 Miata Sport, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System LF] >> DTC P0610
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P0610

DTC P0610  PCM vehicle options error 
DETECTION CONDITION 
  • The PCM data configuration error.

Diagnostic support note 
  • This is a continuous monitor (CCM).
  • The MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA (Mode 2/Mode 12) is available.
  • The DTC is stored in PCM memory.
POSSIBLE CAUSE 
  • Configuration procedure has not been completed
  • PCM malfunction
DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA (MODE 12) HAS BEEN RECORDED 
  • Has the FREEZE FRAME DATA (Mode 12) been recorded?
 Yes Go to the next step.
No Record the FREEZE FRAME DATA (Mode 12) on the repair order, then go to the next step.
2 VERIFY RELATED SERVICE BULLETINS AVAILABILITY 
  • Verify related Service Bulletins availability.
  • Is any related Service Bulletins available?
 Yes Perform the repair or diagnosis according to the available Service Bulletins.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 VERIFY PCM CONFIGURATION HAS BEEN PERFORMED 
  • Perform the "PCM CONFIGURATION".

    (See PCM CONFIGURATION ).

  • Turn the ignition switch to the ON position (Engine off).
  • Clear the DTC from the PCM memory using the M-MDS.
  • Start the engine and warm it up completely.
  • Perform the Drive Mode 03 (PCM Adaptive Memory Production, EGR System, A/F Sensor Heater, HO2S Heater, A/F Sensor, HO2S, and TWC Repair Verification Drive Mode).

    (See OBD-II DRIVE MODE ).

  • Is the same DTC present?
 Yes Perform the "PCM CONFIGURATION" again, then go to the next step.
(See PCM CONFIGURATION ).
No Go to the Step 5.
4 VERIFY TROUBLESHOOTING OF DTC P0610 COMPLETED 
  • Turn the ignition switch to the ON position (Engine off).
  • Clear the DTC from the PCM memory using the M-MDS.
  • Perform the KOEO or KOER self test.

    (See KOEO/KOER SELF TEST ).

  • Is the same DTC present?
 Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION ).
No Go to the next step.
5 VERIFY AFTER REPAIR PROCEDURE 
 Yes Go to the applicable DTC inspection.
(See DTC TABLE ).
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals