Function Inspection Using M-MDS

STEP	INSPECTION	RESULTS	ACTION
1	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
1		No	Go to the next step.
2	PURPOSE: VERIFY IF BATTERY VOLTAGE IS FALSELY RECOGNIZED BY DTC RELATED CURRENT SENSOR Switch the ignition off, then ON (engine off). Perform the Pending Trouble Code Access Procedure and DTC Reading Procedure. (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .) Is the PENDING CODE/DTC P058A:00 also present?	Yes	Go to the applicable PENDING CODE or DTC inspection. (See DTC P058A:00: [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .) Go to the next step.
2		No	Go to the next step.
3	PURPOSE: VERIFY IF BATTERY VOLTAGE IS FALSELY RECOGNIZED BY DTC RELATED CAN OR LIN COMMUNICATION Perform the PCM and front body control module (FBCM) DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .) (See DTC INSPECTION [FRONT BODY CONTROL MODULE (FBCM)] .) Are DTCs related CAN or LIN communication recorded?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .) (See DTC TABLE [FRONT BODY CONTROL MODULE (FBCM)] .) Go to the next step
3		No	Go to the next step
4	PURPOSE: VERIFY IF A MALFUNCTION OCCURRED DUE TO FAILURE OF PERFORMING THE BATTERY INITIAL SETTING Access the BATT_DAY PID using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .) Has it only been a short while since the battery was replaced?	Yes	Verify the battery replacement record (servicing record or consultation with customer), and if it can be determined that the battery initial setting was not performed, perform the battery initial setting. (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .) Go to the TROUBLESHOOTING PROCEDURE to perform the procedure from Step 2.
4		No	Go to the TROUBLESHOOTING PROCEDURE to perform the procedure from Step 1.