DTC P0721: 00 Output Shaft Speed Sensor/Sensor Output Range Malfunction: Notes
DTC P0721:00 DETECTION CONDITIONS AND POSSIBLE CAUSES (FW6A-EL)
| DTC P0721:00 |
Output shaft speed sensor/sensor output range malfunction |
| DETECTION CONDITION |
- Under the following condition, the output shaft speed is 13, 560 rpm or more
in forward or 2, 000 rpm or more
in reverse for a continuous 1 s
:
- Battery voltage is 8 V or more.
Diagnostic support note
- The check engine light illuminates if the TCM detects the above malfunction condition during the first drive cycle.
- The automatic transaxle warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle.
- PENDING CODE is available.
- FREEZE FRAME DATA is available.
- DTC is stored in the TCM memory.
|
| FAIL-SAFE FUNCTION |
- Inhibits learning control.
- Inhibits manual mode.
- Inhibits neutral idle control.
- Inhibits AAS.
|
| POSSIBLE CAUSE |
- Output shaft speed sensor malfunction
|
| SYSTEM WIRING DIAGRAM |
Not applicable |