Visual Inspection
CAUTION:
- When replacing the CKP sensor, make sure there is no foreign matter on it such as metal shavings. If it is installed with foreign matter, the sensor output signal will malfunction resulting from fluctuation in magnetic flux and cause a deterioration in engine control.
- Turn the steering wheel to full right lock.
- Disconnect the negative battery cable. (Refer to NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
- Lift up the vehicle.
- Perform the following procedure for easier access.
- Remove the service hole cover (installed to front under cover No. 2) used to remove the oil filter. (Refer to OIL FILTER REPLACEMENT [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
- Remove the front splash shield (RH). (Refer to SPLASH SHIELD REMOVAL/INSTALLATION .)
- Disconnect the CKP sensor connector.
- Remove the CKP sensor. (Refer to CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION .)
- Verify that there are no metal shavings on the sensor.
- If there is a malfunction, remove any metal shavings that are adhering.