Diagnostic Procedure

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA/SNAPSHOT DATA HAS BEEN RECORDED Has the freeze frame data/snapshot data been recorded on the repair order?	Yes	Go to the next step.
1		No	Record the freeze frame data/snapshot data on the repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	INSPECT ATF LEVEL Inspect the ATF level. (Refer to AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION [FW6A-EL] .) Is there any malfunction?	Yes	Adjust the ATF level to the specification, then go to Step 5. (Refer to AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [FW6A-EL] .)
3		No	Go to the next step.
4	INSPECT OIL COOLER Visually inspect the oil cooler. Is there any malfunction?	Yes	Replace the oil cooler, then go to the next step. (Refer to OIL COOLER REMOVAL/INSTALLATION [FW6A-EL] .)
4		No	Go to the next step.
5	VERIFY DTC TROUBLESHOOTING COMPLETED Clear the DTC using the M-MDS. (Refer to ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [FW6A-EL] .) Perform the following procedure to ensure that the DTC has been resolved: Start the engine and wait for 10 s or more . Perform the DTC inspection using the M-MDS. (Refer to ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [FW6A-EL] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (Refer to ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [FW6A-EL] .)
5		No	DTC troubleshooting completed.