| DTC P0722:00 |
Open circuit in output shaft speed sensor circuit |
| DETECTION CONDITION |
- Under the following conditions, the output shaft speed sensor signal is not input for 1 s
:
- Engine is running.
- Vehicle speed signal related DTC is not recorded.
- Vehicle speed is 16 km/h {9.9 mph} or more
.
- There is no difference between vehicle speed signal from DSC HU/CM and output shaft speed sensor signal.
- DTC U0121:00 is not recorded.
Diagnostic support note
- The check engine light illuminates if the TCM detects the above malfunction condition during the first drive cycle.
- The automatic transaxle warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle.
- PENDING CODE is available.
- FREEZE FRAME DATA is available.
- DTC is stored in the TCM memory.
|
| FAIL-SAFE FUNCTION |
- Inhibits learning control.
- Inhibits manual mode.
- Inhibits neutral idle control.
- Inhibits AAS.
|
| POSSIBLE CAUSE |
- Output shaft speed sensor malfunction
|
| SYSTEM WIRING DIAGRAM |
Not applicable |