Snapshot data item table
NOTE:
- Refer to PID/DATA monitor table for confirm the transaxle control system operation status while the TCM does not store the DTC. (Refer to ON-BOARD DIAGNOSTIC SYSTEM PID/DATA MONITOR INSPECTION [FW6A-EL] .)
- Snapshot data items are not displayed, according to detected DTC.
| -: Not applicable | |||
|---|---|---|---|
| Snapshot data item | Unit | Description | Corresponding PID/DATA monitor item |
| LOAD | % | Calculated engine load | - |
| ECT | °C {°F} | Engine coolant temperature | ECT |
| RPM | RPM | Engine speed | RPM |
| VSS | KPH | Vehicle speed | VSS |
| IAT | °C {°F} | Intake air temperature | - |
| EG_RUN_TIME | - | Time from engine start | - |
| VPWR | V | Module supply voltage | VPWR |
| APP1 | % | Accelerator pedal position No. 1 | APP1 |
| GEAR_SEL | 1/2/3/4/5/6 | Gear shift position | GEAR_SEL |
| TSS | RPM | Turbine/input shaft speed | TSS |
| TFT | °C {°F} | ATF temperature | TFT |
| OSS | RPM | Output shaft speed | OSS |
| LOCK_UP | Off/SLIP/On | Torque converter (TCC condition) | LOCK_UP |
| OIL_PRES_SW2 | Off/On | Oil pressure switch No. 2 condition | OP_SW2 |
| OIL_PRES_SW1 | Off/On | Oil pressure switch No. 1 condition | OP_SW1 |
| SS_ON_OFF | Off/On | On/off solenoid condition | SS_ON-OFF |
| TORQUE_DES | Nm | Desired engine torque | TORQUE_DES |
| APP | % | Accelerator pedal position No. 1 | APP |
| G_INHIBIT_6 | Off/On | 6GR is inhibited due to malfunction. | - |
| G_INHIBIT_5 | Off/On | 5GR is inhibited due to malfunction. | - |
| G_INHIBIT_4 | Off/On | 4GR is inhibited due to malfunction. | - |
| G_INHIBIT_3 | Off/On | 3GR is inhibited due to malfunction. | - |
| G_INHIBIT_2 | Off/On | 2GR is inhibited due to malfunction. | - |
| G_INHIBIT_1 | Off/On | 1GR is inhibited due to malfunction. | - |
| G_INHIBIT_R | Off/On | R position is inhibited due to malfunction. | - |
| G_INHIBIT_N | Off/On | N position is inhibited due to malfunction. | - |
| OIL_PRES_SW4 | Off/On | Oil pressure switch No. 4 condition | OP_SW4 |
| OIL_PRES_SW3 | Off/On | Oil pressure switch No. 3 condition | OP_SW3 |
| SHIFT_CTRL | DEFAULT/MANUAL/C_CONTROL/HIGH_TEMP/D_MANUAL/FAIL_SAFE | Shift control mode | SHIFT_CTRL |
| SLIP_VALUE | RPM | Actual slip value between TSS and OSS | - |
| HTM_DIS | km | Travel distance since determination of ATF high temperature mode | HTM_DIS |
| MST_REC_SFT | - | The gear shift position before shifting gears is displayed. | SE_TYPE |
| SFT_CTL_STS | - | The shift control execution condition is displayed. | SC_STATE |
| SERIAL_DTC | - | DTC | - |
| TR | - | Transaxle range sensor position. | TR |
| PADDLE_UP | Off/On | Shift up operation using steering shift switch. | PADDLE_UP |
| PADDLE_DOWN | Off/On | Shift down operation using steering shift switch. | PADDLE_DOWN |