DTC C0061-28/C0061-64/C0063-28/C0063-64: SAS Control Module System (DSC): Notes
DTC C0061:28/C0061:64/C0063:28/C0063:64 (DYNAMIC STABILITY CONTROL) DETECTION CONDITION AND POSSIBLE CAUSE
| DTC |
C0061:28, C0061:64, C0063:28, C0063:64 |
SAS control module system |
| DETECTION CONDITION |
NOTE:
- The low-G sensor and the yaw rate sensor are built into the SAS control module.
- C0061:28, C0061:64
- Out-of-specification signal modulation or lateral-G value is detected from the low-G sensor.
- C0063:28, C0063:64
- Out-of-specification signal modulation or yaw rate value is detected from the yaw rate sensor.
|
| FAIL-SAFE FUNCTION |
- Illuminates the TCS/DSC indicator light.
- Inhibits the TCS (engine control) and DSC controls.
|
| POSSIBLE CAUSE |
- SAS control module malfunction
- Open or short circuit in the CAN2_H wiring harness between DSC HU/CM terminal AO and SAS control module terminal 2H
- Open or short circuit in the CAN2_L wiring harness between DSC HU/CM terminal AL and SAS control module terminal 2D
- DSC HU/CM malfunction
- Poor connection at connectors (female terminal)
|
 Courtesy of MAZDA MOTORS CORP.
|