LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2016 >> 6 Sport, Automatic Trans >> Repair and Diagnosis (Single Page) >> Body & Frame >> Headlight Doors >> Lighting System >> Auto Leveling Sensor Inspection
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Auto Leveling Sensor Inspection

  1. Remove the auto leveling sensor. (See AUTO LEVELING SENSOR REMOVAL/INSTALLATION .)
  2. Prepare three dry cell batteries (1.5 V  ).
  3. Connect the three dry cell batteries in a series.
    Fig 1: Identifying Dry Cell Battery
    G10988001Courtesy of MAZDA MOTORS CORP.
  4. Connect the positive pole of the dry cell battery to auto leveling sensor terminal C, and the negative pole to terminal A.
    Fig 2: Connecting Positive Pole Of Dry Cell Battery To Auto Leveling Sensor Terminal C
    G10988002Courtesy of MAZDA MOTORS CORP.
  5. Connect the tester as shown in the figure with approx. 4.5 V  of voltage applied between auto leveling sensor terminals A and C, and measure the voltage at auto leveling sensor terminal B.
    Fig 3: Measuring Voltage At Auto Leveling Sensor Terminal B
    G10988003Courtesy of MAZDA MOTORS CORP.
  6. When slowly moving the auto leveling sensor link up and down, verify that the voltage fluctuates linearly between 0.5-4.5 V  as shown in the figure.
    Fig 4: Auto Leveling Sensor Voltage Graph
    G10988004Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals