Engine Oil Solenoid Valve Control System Inspection
WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the M-MDS to the DLC-2.
- Perform the KOER self test. (See KOEO/KOER SELF TEST [SKYACTIV-G 2.5] .)
- Verify that DTC P06DA:00 is not displayed. (See
ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.5]
.)
- If DTC P06DA:00 is displayed, perform the DTC inspection. (See DTC P06DA:00 [SKYACTIV-G 2.5] .)
- Inspect the engine oil pressure. (See
OIL PRESSURE INSPECTION
.)
- If the engine oil pressure is not as specified, repair or replace the malfunctioning part according to the inspection results:
- Access the following PCM PIDs using the M-MDS. (See
ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.5]
.)
- OIL_P_SOL
- RPM
- ECT
- With the engine coolant temperature at 98 °C {208 °F}
, increase the engine speed to 4, 000 rpm or higher
, and verify that the oil pressure gauge value changes when the data monitor item OIL_P_SOL value is changed from ON to OFF.
- If the oil pressure gauge value change cannot be verified, inspect the engine oil solenoid valve. (Perform the Engine Oil Solenoid Valve Operation Inspection.) (See ENGINE OIL SOLENOID VALVE INSPECTION .)
RELATED PIDS SPECIFICATION
| Item (definition) | Unit/Condition | Definition | Condition/Specification (Reference) |
|---|---|---|---|
| ECT | °C, °F | Engine coolant temperature (No. 1) |
|
| V |
|
||
| OIL_P_SOL | Off/On | Engine oil solenoid valve |
|
| RPM | RPM | Engine speed |
|