LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2016 >> 6 Touring, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Entertainment System) >> Condenser Removal/Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Condenser Removal/Installation

WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.5] .)
  2. Remove the following parts:
    1. Rear scuff plate (LH) (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Rear seat cushion (LH) (See REAR SEAT CUSHION REMOVAL/INSTALLATION .)
    3. Rear side seat back (LH) (See REAR SEAT BACK REMOVAL/INSTALLATION .)
    4. Tire house trim (LH) (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
    5. C-pillar trim (LH) (See C-PILLAR TRIM REMOVAL/INSTALLATION .)
  3. Disconnect the connector.
  4. Remove the bolt.
  5. Remove the condenser.
  6. Install in the reverse order of removal.
    Fig 1: C-Pillar Trim (LH) And Bolt With Torque Specifications
    G09788380Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals