Auto Reverse Pinch Protection Function Inspection
POWER WINDOW SYSTEM PRELIMINARY - AUTO REVERSE PINCH PROTECTION FUNCTION INSPECTION PROCEDURE
| STEP |
INSPECTION |
ACTION |
| 1 |
- Switch the ignition ON.
- Fully open the driver-side power window.
- Set the hammer (thickness: 10 mm {0. 39 in} or more) as shown below. Then, close the power window.
- Verify that the power window opens 200 mm {7.87 in} after contacting the hammer and the operation stops.
- Does auto reverse pinch protection function operate properly?
|
Yes |
- Auto reverse pinch protection function is normal.
- Perform the two-step down function inspection.
|
| No |
Go to the next step. |
| 2 |
- Does power window open before contacting the hammer?
|
Yes |
- Go to No. 6 DOOR GLASS REVERSES EVEN THOUGH THE GLASS DOES NOT ENCOUNTER A FOREIGN OBJECT WHILE IT IS MOVING UP IN AUTOMATIC MODE.
|
| No |
- Initialize the power window main switch.
NOTE:
- Before initializing the power window main switch, cut off the power supply to the power window main switch for 60 s. Then, reconnect it again after 60 s:
- Disconnect the negative battery cable.
- Disconnect the power window main switch connector.
- Remove the fuse for the power window system.
|
 Courtesy of MAZDA MOTORS CORP.
|