LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2017 >> 6 Touring, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Dynamic Stability Control System) >> Rear Abs Wheel-Speed Sensor Removal/Installation >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Abs Wheel-Speed Sensor Removal/Installation: Notes

WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the following parts:
    1. Trunk covering (See TRUNK COVERING REMOVAL/INSTALLATION .)
    2. Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION .)
    3. Trunk side pocket (See TRUNK SIDE POCKET REMOVAL/INSTALLATION
    4. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
  2. Disconnect the rear ABS wheel-speed sensor connector.
  3. Press the rear ABS wheel-speed sensor tabs and press out the sensor toward the outside of the vehicle.
  4. Remove in the order indicated in the table.
  5. Install in the reverse order of removal.
  6. After installation, verify that there is no twisting in the rear ABS wheel-speed sensor.
    Fig 1: Pressing Rear ABS Wheel-Speed Sensor Tabs
    G09785874Courtesy of MAZDA MOTORS CORP.
    Fig 2: Rear ABS Wheel-Speed Sensor Bolt With Torque Specification
    G09785875Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals