Power Window System Initialization Procedure
NOTE:
- If the following operations have been performed, the initial settings are reset, and auto operation is disabled. Therefore, performing the initial setting is necessary.
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
- Disconnect the power window main switch connector.
- Remove the power window system power supply fuse.
- Switch the ignition ON (engine off or on).
- Press the driver's switch on the power window main switch to fully open the front door glass (driver's side).
- Pull up the driver's switch on the power window main switch to the top position to fully close the front door glass (driver's side), and keep holding the switch up at the position for approx. 2 s or more.