LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2017 >> CX-9 Signature >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (Dynamic Stability Control System (Service Information)) >> DSC Related Parts Sensor Initialization Procedure >> When using M-MDS
April 5, 2026: LEMON Manuals is launched! Read the announcement.

When using M-MDS

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the wheel alignment and the tire pressure.
    • If there is any malfunction, adjust the applicable part.
  2. Position the vehicle on level ground.
  3. Switch the ignition off.
  4. Connect the M-MDS to DLC-2.
  5. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
    1. Select "Chassis".
    2. Select "ABS/DSC".
    3. Select "Sensor Initialization".
  6. Then, select an item from the screen menu.
    • "Brake fluid pressure sensor"
    • "Lateral Acceleration Sensor"
    • "Yaw Rate Sensor"
    • "Longitudinal Acceleration Sensor"
  7. Perform the procedure according to the directions on the screen.
  8. Drive the vehicle.
  9. After 5 min or more of driving, verily that the DSC system is normal.
scientia non olet · About LEMON Manuals