Diagnostic Procedure

DTC U3000:49 (360° VIEW MONITOR CONTROLE MODULE) DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	VERIFY IF MALFUNCTIONING LOCATION IS 360°VIEW MONITOR CONTROL MODULE DEPENDING ON REPEATABILITY Clear the DTC for the 360°view monitor control module using the M-MDS. (See CLEARING DTC (360°VIEW MONITOR CONTROL MODULE) .) Retrieve the 360°view monitor control module DTCs using the M-MDS. (See DTC INSPECTION (360°VIEW MONITOR CONTROL MODULE) .) Is the same Pending DTC present?	Yes	Replace the 360°view monitor control module, then go to the next step. (See 360°VIEW MONITOR CONTROL MODULE REMOVAL/INSTALLATION.)
1		No	Go to the next step.
2	VERIFY IF OTHER DTCs DISPLAYED Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE (360°VIEW MONITOR CONTROL MODULE) .)
2		No	DTC troubleshooting completed.