Diagnostic Procedure
WARNING: This page is about a different car, the 2018 Mazda CX-9. However, it is still accessible from the selected car via links, so may be relevant.
DTC U0533:81 (360°VIEW Monitor Control Module) DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | VERIFY OTHER 360°VIEW MONITOR CONTROL MODULE DTCs
|
Yes | Replace the 360°view monitor control module, then go to Step 4. (See 360°VIEW MONITOR CONTROL MODULE REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 2 | VERIFY BLIND SPOT MONITORING (BSM) CONTROL MODULE (LH) DTCs
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC INSPECTION [BLIND SPOT MONITORING (BSM) CONTROL MODULE] .) |
| No | Go to the next step. | ||
| 3 | VERIFY IF MALFUNCTIONING LOCATION IS BLIND SPOT MONITORING (BSM) CONTROL MODULE (LH) DEPENDING ON REPEATABILITY
|
Yes | Replace the blind spot monitoring (BSM) control module (LH), then go to the next step. (See BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION .) |
| No | Go to Step 5. | ||
| 4 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Repeat the inspection from Step 1.
Go to the next step. |
| No | Go to the next step. | ||
| 5 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE (360°VIEW Monitor Control Module) .) |
| No | DTC troubleshooting completed. | ||