Caliper (Front) Disassembly/Assembly: Notes
WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Brake fluid will damage painted surfaces. Be careful not to spill any on painted surfaces. In addition, if there is any brake fluid on the wiring harness, the wire insulation may corrode causing a malfunction such as a short circuit. If brake fluid gets on a painted surface or wiring harness, wash and flush it off completely with water immediately.
- Disassemble in the order indicated in the table.
World manufacturer identification "JM1"
Fig 1: Disassembling/Assembling Caliper (Front) With Torque Specification - World Manufacturer Identification "JM1"Courtesy of MAZDA MOTORS CORP.
COMPONENT DESCRIPTION1 Bleeder cap 2 Bleeder screw 3 Piston
(See Piston Disassembly Note .)4 Dust seal 5 Piston seal 6 Caliper body World manufacturer identification "3MZ"
Fig 2: Disassembling/Assembling Caliper (Front) With Torque Specification - World Manufacturer Identification "3MZ"Courtesy of MAZDA MOTORS CORP.
COMPONENT DESCRIPTION1 Bleeder cap 2 Bleeder screw 3 Piston
(See Piston Disassembly Note .)4 Dust seal 5 Piston seal 6 Caliper body - Assemble in the reverse order of removal