LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2018 >> MX-5 Miata Club, Standard Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> On-Board Diagnostic - SAS Control Module - Two-Step Deployment Control System >> PID/Data Monitor Table (SAS Control Module (Two-Step Deployment Control System))
April 5, 2026: LEMON Manuals is launched! Read the announcement.

PID/Data Monitor Table (SAS Control Module (Two-Step Deployment Control System))

PID Unit/Condition Data contents SAS control module terminal
AB_WL
(Air bag system warning light status)		 Lamp_Off/Lamp_On/Plant_Mode/Unknown
  • Air bag system warning light off: Lamp_Off
  • Air bag system warning light on: Lamp_On
  • Air bag system warning light status: Plant_Mode
  • Air bag system warning light status: Unknown
 3Q, 3S
OCS_DTC_CLR
(Occupant classification sensor DTC cleared status)		 Starting/Normal End/In Process/OCS Fault Fault information cleared status occupant classification sensor 3Q, 3S
P_OCS_ST
(Occupant classification sensor status)		 Empty/SMALL/Indeterminate/LARGE Occupant classification status determinated by occupant classification sensor 3Q, 3S
PCD_A
(Poorly connected detector bar terminal voltage nominal (SAS control module connector A))		 V
  • Normal connected: 0.27 V or less
  • Poor connected: 3.17 V or more
 1a, 1b
PCD_B
(Poorly connected detector bar terminal voltage nominal (SAS control module connector B))		 V
  • Normal connected: 0.27 V or less
  • Poor connected: 3.17 V or more
 2a, 2b
PCD_C
(Poorly connected detector bar terminal voltage nominal (SAS control module connector C))		 V
  • Normal connected: 0.27 V or less
  • Poor connected: 3.17 V or more
 3a, 3b
RES_F_AB1_D
(Driver-side air bag module (inflatorNo. 1) resistance nominal)		 ohm Continuous: 1.37-6.33 ohms 3C, 3G
RES_F_AB1_P
(Passenger-side air bag module (inflatorNo. 1) resistance nominal)		 ohm Continuous: 0.88-6.33 ohms 3K, 3N
RES_F_AB2_D
(Driver-side air bag module (inflatorNo. 2) resistance nominal)		 ohm Continuous: 1.37-6.33 ohms 3U, 3W
RES_F_AB2_P
(Passenger-side air bag module (inflator No. 2) resistance nominal)		 ohm Continuous: 0.88-6.33 ohms 3AA, 3Z
RES_S_AB_D
(Driver-side side air bag module resistance nominal)		 ohm Continuous: 0.88-10.53 ohms 1C, 1G
RES_S_AB_P
(Passenger-side side air bag module resistance nominal)		 ohm Continuous: 0.88-10.53 ohms 1K, 1N
RES_SB_LP_D
(Driver-side lap pre-tensioner seat belt resistance nominal)		 ohm Continuous: 0.88-6.33 ohms 2B, 2F
RES_SB_P_D
(Driver-side pre-tensioner seat belt resistance nominal)		 ohm Continuous: 0.88-6.33 ohms 2C, 2G
RES_SB_P_P
(Passenger-side pre-tensioner seat belt resistance nominal)		 ohm Continuous: 0.88-6.33 ohms 2K, 2N
SEAT_B_D
(Driver-side buckle switch status)		 Unbuckled/Buckled
  • Driver-side seat belt fastened (Driver-side buckle switch off): Buckled
  • Driver-side seat belt not fastened (Driver-side buckle switch on): Unbuckled
 2U
SEAT_B_P
(Passenger-side buckle switch status)		 Unbuckled/Buckled
  • Passenger-side seat belt fastened (Passenger-side buckle switch off): Buckled
  • Passenger-side seat belt not fastened (Passenger-side buckle switch on): Unbuckled
 2W
VPWR_IGA
(SAS control module power voltage)		 V Ignition is switched ON: IG1 voltage 2AD
scientia non olet · About LEMON Manuals