Manual Mode Function Inspection

BASIC POWER WINDOW SYSTEM DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	Switch the ignition ON (engine off or on). Turn the power-cut switch to UNLOCK (contact point: Close). Does each door glass move up and down in manual mode using the power window subswitch?	Yes	Go to the next step.
1		No	Inspect the following items: Power window main switch (power-cut switch system malfunction) Power window subswitch power supply fuses Power window subswitch ground wiring harness Power window subswitch power supply wiring harnesses Wiring harness between power window subswitch and power window motor Power window subswitch Power window motor Repair or replace the malfunctioning part, then go to the next step.
2	Does the driver-side door glass move up and down in manual mode using the power window main switch?	Yes	Go to the next step.
2		No	Inspect the following items: Power window main switch power supply fuses Power window main switch ground wiring harness Power window main switch power supply wiring harnesses Wiring harness between power window main switch and power window motor Power window main switch Repair or replace the malfunctioning part, then go to the next step.
3	Does each other door glass other than the driver-side door glass move up and down in manual mode using the power window main switch?	Yes	Go to the next step.
3		No	Perform the power window initialization procedure for any door glass that does not move up and down, and reinspect. (See POWER WINDOW SYSTEM INITIALIZATION PROCEDURE .) If it does not move up and down upon reinspection, inspect the following: Wiring harness between power window main switch and subswitch Repair or replace the malfunctioning part, then go to the next step.
4	Turn the power-cut switch to LOCK (contact point: Open). Push/pull the power window main switch (switches for all windows in manual mode). Does only driver-side front door glass move up and down?	Yes	Manual mode function is normal. Go to the automatic mode function inspection.
4		No	Replace the power window main switch, then go to the automatic mode function inspection, (power-cut switch system malfunction)