LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2019 >> 6 Signature >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Front Suspension System) >> Front Stabilizer Installation >> Front Stabilizer Bracket Installation Note
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Stabilizer Bracket Installation Note

WARNING: This page is about a different car, the 2018 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the front stabilizer bracket cannot be installed by hand, install it using a vise.
    CAUTION:
    • The front stabilizer bracket may be deformed if it is installed using a vise. When installing the front stabilizer bracket using a vise, set the cylinder-shaped parts as shown in the figure below so that pressure is applied to the front stabilizer bracket flange, and install the front stabilizer bracket to the front stabilizer bushing.
Fig 1: Front Stabilizer Bracket Using Vise
G12232401Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals