Power Door Lock System
Using M-MDS
- Connect the M-MDS to DLC-2.
- After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- Select the "Module Programming".
- Select "Programmable Parameters".
- Select menu in the SSU.
- Select an item name, and then select option.
SETTING CONTENT FUNCTION DESCRIPTION
| M-MDS display | Function | Setting contents | Control unit |
|---|---|---|---|
| Unlock Mode (With Touch Sensor) | 2-step unlocking system can be set. | Touch Once: All Doors./Once: Driver's, Twice: All Doors. | Start stop unit |
| Unlock Mode (Without Touch Sensor) | 2-step unlocking system can be set. | Touch Once: All Doors./Once:Driver's, Twice: All Doors. | Start stop unit |
- For the auto door lock function, refer to the personalization features for the RBCM. (See CONTROL SYSTEM PERSONALIZATION FEATURES SETTING PROCEDURE .)
Setting method by operation of remote transmitter button
- The following setting can be changed by operation of the remote transmitter button.
SETTING CONTENT FUNCTION DESCRIPTION
| Function | Setting content | Control unit | ||
|---|---|---|---|---|
| 2-step unlocking function.(1) | OFF/ON | Start stop unit | ||
|
||||
- Change the setting for the 2-step unlocking function referring to the following procedure:
NOTE:
- If any of the following conditions is met during procedure, the setting for changing the keyless beeper volume is finished.
- The ignition is switched to ACC or ON (engine off or on).
- The driver's door is closed.
- The liftgate is open.
- The remote transmitter operation is not performed for approx. 10 s.
- The lock button on the remote transmitter is pressed.
- A request switch is pressed.
Using center display