LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2020 >> 6 Signature >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Power Systems) >> Fuse Block Removal/Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuse Block Removal/Installation: Removal

WARNING: This page is about a different car, the 2018 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Front scuff plate (LH) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Front side trim (LH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
    3. LF control unit (with advanced keyless entry system) (See LF CONTROL UNIT REMOVAL/INSTALLATION .)
  3. Remove all the fuses.
  4. Cut the band shown in the figure below.
    Fig 1: Fuse Block, Clip, Tab And Bolt
    G12237494Courtesy of MAZDA MOTORS CORP.
  5. Remove the bolt.
  6. Remove the fuse block clip from the body.
  7. Disconnect the connector.
    Fig 2: Fuse Block And Connector
    G12237495Courtesy of MAZDA MOTORS CORP.
  8. Set the removed fuse block aside so that it does not scratch the vehicle and parts.
scientia non olet · About LEMON Manuals