PID/Data Monitor Table
-: Not applicable
PID/DATA MONITOR (ADAPTIVE FRONT LIGHTING SYSTEM)
| PID |
Unit/Operation |
Data contents |
Inspection item(s) |
| AFS_ST |
Off/On |
- Off: AFS is not operated.
- On: AFS is operated.
|
AFS control module |
| H/L_BO_L |
OK/NG |
Displays the headlight LO (LH) open circuit detection status. (Detects during low beam on) |
LED headlight |
| H/L_BO_R |
OK/NG |
Displays the headlight LO (RH) open circuit detection status. (Detects during low beam on) |
LED headlight |
| R_HGT_S |
V |
Voltage at auto leveling sensor is displayed. |
Auto leveling sensor |
| R_HGT_S_INI |
V |
Voltage at headlight auto leveling system initial setting is displayed. |
Auto leveling sensor |
| STR_AB_ANG |
° (deg) |
Displays steering angle signal (estimated absolute angle)
- Steering wheel in neutral position: Near 0 degrees
- Steering wheel turned to left: Changes from 0 degrees to positive
- Steering wheel turned to right: Changes from 0 degrees to negative
|
- Perform the DTC inspection for the PCM, DSC HU/CM, and EPS CM, and if any DTC is displayed, repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [SKYACTIV-G 2.0]
.) (See DTC TABLE [DSC HU/CM]
.) (See DTC TABLE [EPS CONTROL MODULE]
.)
- After performing the DTC inspection, perform the following procedures:
- Switch the ignition off, and after 2 min or more have elapsed, switch the ignition ON (engine off or on).
- Start the engine and drive the vehicle 10 m {33 ft} or more in a straight line at a speed of 10 km/h {6.2 mph} or more.
- Stop the vehicle with the wheels in the straight-ahead position.
- Verify the operation condition of STR_AB_ANG using the M-MDS.
- If an abnormal value is indicated again, replace the EPS CM. (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION
.)
|
| VPWR_IG |
V |
AFS control module power supply voltage is displayed. |
- AFS control module
- IG1 relay
- Battery
|
| VSPD |
KPH, MPH |
Vehicle speed is displayed. |
- |