Engine Oil Level Inspection

WARNING: This page is about a different car, the 2016 Mazda CX-3. However, it is still accessible from the selected car via links, so may be relevant.

Position the vehicle on level ground.
Warm up the engine.
Stop the engine and allow At Least 5 Min before continuing.
Remove the dipstick, wipe it cleanly, and reinstall it fully.
Remove the dipstick and verify that the oil level is between the F and L marks on the dipstick.

Fig 1: Engine Oil Level Marks On Dipstick
Courtesy of MAZDA MOTORS CORP.
- If the oil level is below or near the L mark, add engine oil. (Refer to ENGINE OIL REPLACEMENT .)
- If the oil level is above the F mark, penetration of fuel into the engine oil can be considered. Replace the engine oil. (Refer to ENGINE OIL REPLACEMENT .)
Insert the oil level gauge completely until it attaches to the cylinder head cover.