Function Inspection Using M-MDS

DIAGNOSTIC PROCEDURE - FUNCTION INSPECTION USING M-MDS

Step	Inspection	Results	Action
1	PURPOSE: RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION Record the freeze frame data/snapshot data. NOTE: Recording can be facilitated using the screen capture function of the PC.	-	Go to the next step.
2	PURPOSE: VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY Verify related Service Bulletins, on-line repair information, or Service Information availability. Is any related Information available?	Yes	Perform repair or diagnosis according to the available information. If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	PURPOSE: INSPECT FOR OTHER RELATED DTCs Perform the DTC inspection for the PCM. (See DTC INSPECTION .) Are any other DTCs displayed?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE (US) .)
3		No	Go to the next step.
4	PURPOSE: VERIFY IF THERE IS PID ITEM CAUSING DRASTIC CHANGES OF ACCELERATION FLUCTUATION BY INPUT SIGNAL TO PCM Access the following PIDs using the M-MDS: (See PID/DATA MONITOR INSPECTION .) PCM: ENG_OIL_LVL Is the PID value within specification? (See ENGINE OIL LEVEL SENSOR INSPECTION (VIN M) .) (See ENGINE OIL LEVEL SENSOR INSPECTION (VIN L) .)	Yes	Go to the next step.
4		No	Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 1.
5	PURPOSE: VERIFY CONNECTOR CONNECTIONS Access the following PIDs using the M-MDS: (See PID/DATA MONITOR INSPECTION .) PCM: ENG_OIL_LVL When the following parts are shaken, does the PID value include a PID item which has changed? Engine oil level sensor PCM	Yes	Repair or replace the applicable connector parts. Go to Troubleshooting Diagnostic Procedure to perform the repair completion verification.
5		No	Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 1.