Start Stop Unit Inspection: Notes
NOTE:
- Because the start stop unit terminals 3A-3L and 4A-4L are inside the start stop unit and not exposed, the terminal voltage cannot be measured.
- Terminals with terminal voltage that cannot be measured are not indicated in the terminal voltage table (reference).
- Remove the following parts:
- Column cover (See COLUMN COVER REMOVAL/INSTALLATION .)
- Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).
- If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s) and related wiring harnesses.
- If the system does not work normally even though the inspection items or related wiring harnesses do not have any malfunction, replace the start stop unit.