Diagnostic Procedure

DTC U3000:42 (AUTO LEVELING CONTROL MODULE) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	INSPECT AUTO LEVELING CONTROL MODULE FOR MALFUNCTION Clear the DTC recorded in the memory. (See CLEARING DTC .) Perform the DTC inspection for the auto leveling control module. (See DTC INSPECTION .) Is the same Pending DTC present?	Yes	Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW (US) .) If the CAN communication is normal, replace the auto leveling control module and perform the repair completion verification.
1		No	Go to the next step.
Repair completion verification	VERIFY IF OTHER DTC IS DISPLAYED Perform the DTC inspection. (See DTC INSPECTION .) Are any other DTCs displayed?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting.
Repair completion verification		No	DTC troubleshooting completed.