Front ABS Wheel-Speed Sensor Wiring Harness And Clip Disconnection Note

WARNING: This page is about a different car, the 2018 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Refer to this note only if the disconnection of the front ABS wheel-speed sensor wiring harness and the clip shown in the figure below is required.

Fig 1: Disconnecting Front ABS Wheel-Speed Sensor Wiring Harness And Clip

Courtesy of MAZDA MOTORS CORP.

Insert a flathead screwdriver from the side where there is no notch as shown in the figure below.

Fig 2: Inserting Flathead Screwdriver
Courtesy of MAZDA MOTORS CORP.
Detach the tab as shown in the figure below and disconnect the front ABS wheel-speed sensor wiring harness and clip.

Fig 3: Disconnecting Front ABS Wheel-Speed Sensor Wiring Harness And Clip
Courtesy of MAZDA MOTORS CORP.