Verify fuse block replacement
WARNING: This page is about a different car, the 2016 Mazda CX-3. However, it is still accessible from the selected car via links, so may be relevant.
- Temporarily connect the negative battery cable to verify that the related wiring harness is not heated.
- Switch the ignition ON (engine off).
- Verify that the fuse is not blown and the related wiring harness is not heated.
- Perform the initial settings for the following systems:
- Power window system (See POWER WINDOW SYSTEM INITIALIZATION PROCEDURE .)
- Clock and audio
- Verify DTCs using the M-MDS.
- If a DTC is displayed, repair the malfunctioning part according to the corresponding DTC inspection.
- After completion of repairs, clear all DTCs stored in the module.
- If a DTC is displayed, repair the malfunctioning part according to the corresponding DTC inspection.
- Connect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
- Start the engine and maintain the idle status.
- Operate all the switches of the interior/exterior lights of the vehicle and verify that all the lights illuminate and flash.
- Operate the audio, climate control, wiper switch, and selector lever and verify that they operate correctly.
- Shift the selector lever to the P position, race the engine at approx. 3, 000 rpm from engine idling, and verify that there is no malfunction.
- Perform a road test and verify that low speed, acceleration, shift-up, and shift-down conditions are normal.