Function Inspection Using M-MDS

DTC P2B61:00 DIAGNOSTIC PROCEDURE

STEP	INSPECTION	RESULTS	ACTION
1	PURPOSE: VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or online repair information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
1		No	Go to the next step.
2	PURPOSE: RECORD VEHICLE STATUS AT TIME OF DTC DETECTION TO UTILIZE WITH REPEATABILITY VERIFICATION NOTE: Recording can be facilitated using the screen capture function of the PC. Record the FREEZE FRAME DATA/snapshot data on the repair order.	-	Go to the next step.
3	PURPOSE: VERIFY THE INPUT SIGNAL OF THE ENGINE COOLANT CONTROL VALVE POSITION SENSOR Ignition switched ON (engine off) Access the following PIDs using the M-MDS: (See ON-BOARD DIAGNOSTIC TEST .) ENG_CL_V_POS ENG_CL_V_POS_R Is there any signal that is far out of specification?	Yes	Go to the next step.
3		No	Go to Troubleshooting Diagnostic Procedure to perform the procedure from step 1.
4	PURPOSE: VERIFY CONNECTOR CONNECTIONS Start the engine. Access the following PIDs using the M-MDS: (See ON-BOARD DIAGNOSTIC TEST .) ENG_CL_V_POS ENG_CL_V_POS_R When the following parts are shaken, does the PID value include a PID item which has changed? Coolant control valve	Yes	Inspect the related wiring harness and connector. Repair or replace the malfunctioning part.
4		No	Go to Troubleshooting Diagnostic Procedure to perform the procedure from step 1.