Request Switch Inspection: Liftgate

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
Remove the following parts:
1. Rear package tray (See REAR PACKAGE TRAY REMOVAL/INSTALLATION .)
2. Liftgate upper trim (See LIFTGATE UPPER TRIM REMOVAL/INSTALLATION .)
3. Liftgate side trim (See LIFTGATE SIDE TRIM REMOVAL/INSTALLATION .)
4. Liftgate recess (See LIFTGATE RECESS REMOVAL/INSTALLATION .)
5. Liftgate lower trim (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION .)
6. Liftgate garnish (See LIFTGATE GARNISH REMOVAL/INSTALLATION .)
7. Request switch (liftgate) (See REQUEST SWITCH REMOVAL/INSTALLATION .)
Verify that the continuity is as indicated in the table.

Fig 1: Request Switch Continuity Reference Chart (Liftgate)
Courtesy of MAZDA MOTORS CORP.

Fig 2: Checking Request Switch (Liftgate)
Courtesy of MAZDA MOTORS CORP.
- If not as indicated in the table, replace the request switch.