Function Inspection
WARNING: This page is about a different variant/trim than selected.
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Display the PCM PID [BOOST_AIR_TEMP] and [BOOST_AIR_TEMP_VOLT]. (See PID/DATA Monitor Inspection .) (See PID/DATA MONITOR TABLE [PCM (VIN Y)] .)
- Compare the voltage and temperature indications for the PIDs [BOOST_AIR_TEMP_VOLT] and [BOOST_AIR_TEMP] with the standard in the table indicated below.
- If they do not match the standard, perform the resistance inspection. (See Resistance Inspection .)
STANDARD
| PID [BOOST_AIR_TEMP_VOLT] | PID [BOOST_AIR_TEMP] |
|---|---|
| V | °C {°F} |
| Approx. 3.71 | 20 {68.EN_US} |
| Approx. 3.19 | 40 {104.EN_US} |
| Approx. 3.27 | 60 {140.EN_US} |