Diagnostic Procedure

DTC U0416:41 (AUTO LEVELING CONTROL MODULE) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	INSPECT ELECTRONICALLY CONTROLLED BRAKE UNIT FOR MALFUNCTION Perform the DTC inspection for the electronically controlled brake unit. (See DTC INSPECTION .) Is a DTC displayed?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting.
1		No	Go to the next step.
2	INSPECT ELECTRONICALLY CONTROLLED BRAKE UNIT FOR MALFUNCTION DEPENDING ON REPEATABILITY Clear the DTC recorded in the memory. (See CLEARING DTC .) Perform the DTC inspection for the auto leveling control module. (See DTC INSPECTION .) Is the same Pending DTC present?	Yes	Refer to the CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW to inspect for a CAN communication error. If the CAN communication is normal, replace the electronically controlled brake unit and perform the repair completion verification.
2		No	Go to repair completion verification 2.
Repair completion verification 1	VERIFY THAT VEHICLE IS REPAIRED Install/connect the part removed/disconnected during the troubleshooting procedure. Clear the DTC recorded in the memory. (See CLEARING DTC .) Perform the DTC inspection for the auto leveling control module. (See DTC INSPECTION .) Is the same Pending DTC present?	Yes	Refer to the CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW to inspect for a CAN communication error. If the CAN communication is normal, perform the diagnosis from Step 1. If the malfunction recurs, replace the auto leveling control module, then go to the next step. (See AUTO LEVELING CONTROL MODULE REMOVAL/INSTALLATION .)
Repair completion verification 1		No	Go to the next step.
Repair completion verification 2	VERIFY IF OTHER DTC IS DISPLAYED Perform the DTC inspection. (See DTC INSPECTION .) Are any other DTCs displayed?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting.
Repair completion verification 2		No	DTC troubleshooting completed.